Le Sat, 26 Feb 2005 17:43:18 -0600 Bill Wilson <billw@xxxxxxxxxxxxxx> a écrit : > On Sat, 26 Feb 2005 23:07:02 +0100 > Iznogood <iznogood@xxxxxxxxxxxxxxxxxxxx> wrote: > > > Thanks for the job! It's great! Just one thing: when you start a .pcb > > file, the zoom seems one time too large with regard to the zoom button. > > Should have added this to the previous patch. Here's the patch again > with zoom fixed: > > --- gui-top-window.c.orig 2005-02-26 16:44:51.000000000 -0600 > +++ gui-top-window.c 2005-02-26 17:10:45.000000000 -0600 > @@ -2086,6 +2086,8 @@ > gui_route_style_button_set_active(0); > gui_config_handle_units_changed(); > gui_change_selected_update_menu_actions(); > + > + gui_zoom_display_update(); > } > > /* Sync toggle states in the menus at startup to Settings values loaded > @@ -2630,7 +2632,11 @@ > /* Turning off a layer that was selected will cause PCB to switch to > | another layer. > */ > - layer = MIN (INDEXOFCURRENT, GUI_RATS_LAYER); > + if (PCB->RatDraw) > + layer = GUI_RATS_LAYER; > + else > + layer = PCB->SilkActive ? GUI_SILK_LAYER : LayerStack[0]; > + > if (layer < MAX_LAYER) > active = PCB->Data->Layer[layer].On; > else if (layer == GUI_SILK_LAYER) > > > I will be interested with the documentation with another extension > > than .texi and some .pot file to translate it. > > Don't know much about the .texi, but the tarball uploaded now has > a pcb-gtk/po/pcb.pot file that you can start with. I did add i18n to > most of what I did. Some of the popup confirms and other things > probably are missed and I doubt the configure system is set up to > enable i18n. > > Maybe you could succeed "by hand". After the configure you would > have to edit the src/Makefile and change the DEFS line to: > > DEFS = -DHAVE_CONFIG_H -DENABLE_NLS -DPACKAGE=\"pcb\" -DLOCALEDIR=\"/usr/share/locale\" > > Then do a make. And again by hand install the fr.po you have created: > > cd src/po > msgfmt -f -v -o fr.mo fr.po > cp fr.mo /usr/share/locale/fr/LC_MESSAGES/pcb.mo > > Maybe it's better to wait until the PCB build can do it all for you, but while > I know what to do, I don't know how to make the autobuild tools do it. Thanks for the very quick reply. I will do the job tomorow, cause it's too late for tonight and I'm tired! ;-) Cordially. > > Bill > > -- Sur http://www.iznogood-factory.org , vous avez parmi des doc techniques en français, celle de cinglés qui développent des outils pour les schémas électroniques: gEDA.
Attachment:
pgpyTPnGGqNl9.pgp
Description: PGP signature