Re: gEDA-user: Footprint for an SMT chip resistor array

[msokolov@xxxxxxxxxxxxxxx (Michael Sokolov)]

John Luciani <jluciani@xxxxxxxxx> wrote:

> I would go for the concave terminations. The concave may be easier to
> hand solder
> on small pads.

Thanks John, I'll put the EXBV8V with concave pads in there, using the
M4 pcblib footprint.  (Of course this is all very preliminary -- written
with forks on water as we say in Russia -- until the layout is actually
done.)

MS


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user