[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: tqfp

On Sun, Feb 24, 2008 at 4:59 PM, Ian Chapman <ichapman@xxxxxxxxxxxx> wrote:
> Hi,  I am using the footprint SQFP-50P-2280L1-2280L2-144N.fp for a
>  tqfp144.  I've checked a printout of the gerber against an actual device
>  and it looks okay to me.  I just need to check against the rest of the
>  guys for any comments?  Regards Ian.

TQ is thin quad while SQ is square quad (usually thicker than TQ). Compare
the extents of the pads (22.8mm) against the package specification. Sometimes
the TQ is a little smaller but you may be OK.

(* jcl *)


-- 
http://www.luciani.org


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user