[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: Read Garbage errors in gsch2pcb

   I removed the blank line at the end of each file and I'm not getting
   any read garbage errors.  Now it's stalling and shows the following (I
   noticed after the read garbage errors it's stalling at that point with
   the blank lines in also):

   [rob@localhost project-mykoolride]$ gsch2pcb myproject
   ---------------------------------
   gEDA/gnetlist pcbpins Backend
   This backend is EXPERIMENTAL
   Use at your own risk!
   ---------------------------------
   Using the m4 processor for pcb footprints

   What could cause gsch2pcb to stall?

   On Sun, Feb 22, 2009 at 1:31 PM, John Luciani <[1]jluciani@xxxxxxxxx>
   wrote:

     Try removing the blank line at the end of each file.
     (* jcl *)
     --
     You can't create open hardware with closed EDA tools.
     [2]http://www.luciani.org

   _______________________________________________
   geda-user mailing list
   [3]geda-user@xxxxxxxxxxxxxx
   [4]http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

References

   1. mailto:jluciani@xxxxxxxxx
   2. http://www.luciani.org/
   3. mailto:geda-user@xxxxxxxxxxxxxx
   4. http://www.seul.org/cgi-bin/mailman/listinfo/geda-user


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user