Re: gEDA-user: topo router for PCB

[Larry Battraw <lbattraw@xxxxxxxxx>]

On Sun, Feb 21, 2010 at 1:32 PM, Stefan Salewski <mail@xxxxxxxxxxxx> wrote:
> On Sat, 2010-02-20 at 22:20 -0500, Larry Battraw wrote:
>> I had a quick question.  I know there are several sparsely-documented
>>    plugins for PCB but I am trying to locate the one that makes the traces
>>    on the board look like they were laid out by hand the old-fashioned way
>>    with tape, resulting in curving, contoured traces instead of the
>>    standard auto-routed straight
>
> You may looking for the topological router, included in pcb 2009
> snapshot.
>
> http://www.wand.net.nz/~amb33/toporouter/

That's it!!  Thanks so much for your answer the puller and global
puller were somewhat similar but I knew there had to be a way for it
to autoroute that way.  Do you know where the latest code for it can
be found?

Thanks-
Larry


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user