Re: gEDA-user: Creating a polygon without a pruned center

[Kovacs Levente <leventelist@xxxxxxxxx>]

On Wed, 02 Feb 2011 13:13:16 -0500
David Carr <dc@xxxxxxxxx> wrote:

> Hi all,
> 
> Forgive me if this has been asked before, but my searching didn't
> uncover a solution:
> 
> Here's an image of a board with a component and solder side ground
> planes: http://oscar.dcarr.org/tmp/board.png
> 
> I'd like for the top ground plane (tan) to not be pruned in the
> center so that I can connect the "dangling" pieces to the solder side
> ground plane. Is there any way to do this?

I think you want to do this:

select the polygon, issue the command

Morphpoly(selected)

you can do this by pressing the ":" key I guess.
 
> Thanks,
> David Carr
> 
> 
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
> 


-- 
Kovacs Levente <leventelist@xxxxxxxxx>
Voice: +36705071002




_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user