[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
gEDA-user: Board cleaner recommendations
After you get done soldering and fluxing up your board to solder a lot
of SMT components, what do you guys use to get it looking flux-free
and clean again? I tried MG Chemical flux remove and while it does
remove the flux, after washing it (with tap water) and drying it, it
leaves a nasty well-ish film on the board that make it actually look
worse.
_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user