Re: gEDA-user: Board cleaner recommendations

[John Luciani <jluciani@xxxxxxxxx>]

On Wed, Feb 23, 2011 at 2:38 PM, yamazakir2 <yamazakir2@xxxxxxxxx> wrote:
> After you get done soldering and fluxing up your board to solder a lot
> of SMT components, what do you guys use to get it looking flux-free
> and clean again? I tried MG Chemical flux remove and while it does
> remove the flux, after washing it (with tap water) and drying it, it
> leaves a nasty well-ish film on the board that make it actually look
> worse.

Water soluble flux, hot running water and an acid brush with the bristles cut
short.

(* jcl *)


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user