Karel Kulhavy wrote:
Why don't you make a symbol for gschem that represents the shield. Give it one pin. In the schematic connect that one pin to ground. I do this all the time to make holes for ground clips (to clip my oscilloscope probe ground to at convinient locations). Make a foot print for the shield as if it is a component.Hello
I have discovered two problems connected with faking solderable strip at the edge of the board on PCB:
1) It gets into soldermask which breaks the phosphorbronze stencil (the stencil completely falls out of the frame)
2) the ratnest complains about "unknown, pin 1" shorted to ground.
Cl<
Steve Meier