Re: gEDA-user: newbie problem

[Carlos Nieves Ónega <cnieves@xxxxxxxxxx>]

Hi Marc,
If you installed the new symbols overwriting the old ones, and you don't
use embedded symbols in your schematic, the errors should have gone. Can
you post a sample schematic to test it?
Also notice that the geda project manager application 'geda' is not
actively developed...

Regards,

Carlos

El jue, 05-01-2006 a las 01:04 +0000, Marc escribiÃ:
> I downloaded the symbols at CVS compiled and installed them when i run 
> Action >> Create Spice Netlist i see no errors but when i open a 
> terminal and run gnetlist -g drc2 your_schematic.sch -o drc_output.txt i 
> get the following, this was explained to me but i didnt quite follow it 
> :/ cant get rid of these 16 errors 
>                                                        Marc :)
> 
> Checking nets with only one connection...
> 
> Checking type of pins connected to a net...
> ERROR: unknown: T1:4 D1:1 D2:2 connected to unknown: T1:4 D1:1 D2:2
> ERROR: Net unnamed_net7 is not driven.
> ERROR: unknown: D4:1 D3:2 connected to unknown: D4:1 D3:2
> ERROR: Net unnamed_net6 is not driven.
> ERROR: unknown: R1:3 Z1:2 U1:1 connected to unknown: R1:3 Z1:2 U1:1
> ERROR: Net unnamed_net5 is not driven.
> ERROR: unknown: T1:1 V1:2 connected to unknown: T1:1 V1:2
> ERROR: Net unnamed_net4 is not driven.
> ERROR: unknown: T1:2 V1:1 connected to unknown: T1:2 V1:1
> ERROR: Net unnamed_net3 is not driven.
> ERROR: unknown: U1:3 C5:1 C6:1 connected to unknown: U1:3 C5:1 C6:1
> ERROR: Net unnamed_net2 is not driven.
> ERROR: unknown: D5:2 D1:2 D4:2 R1:1 C3:1 C4:2 C1:1 C2:2 connected to 
> unknown: D$ERROR: Net unnamed_net1 is not driven.
> ERROR: unknown: T1:3 D2:1 D3:1 D5:1 C6:2 C5:2 U1:2 R1:2 Z1:1 C3:2 C4:1 
> C1:2 C2:$ERROR: Net GND is not driven.
> 
> Checking unconnected pins...
> 
> Checking slots...
> 
> Checking duplicated slots...
> 
> Checking unused slots...
> 
> No warnings found.
> Found 16 errors.
> 
-- 
Carlos Nieves Ãnega <cnieves@xxxxxxxxxx>