Re: gEDA-user: Solder Mask Clearance

["Mike Hansen" <mehansen10@xxxxxxxxxxx>]

I used to set all my mask to clearance of 1, that worked, however now when I 
go back in and try to set the clearance to 0.06 mils with MinMaskGap nothing 
happens:

MinMaskGap(0.06,mil)

Am I using it wrong or is it a bug?

> From: DJ Delorie <dj@xxxxxxxxxxx>
> Reply-To: gEDA user mailing list <geda-user@xxxxxxxxxxxxxx>
> To: geda-user@xxxxxxxxxxxxxx
> Subject: Re: gEDA-user: Solder Mask Clearance
> Date: Thu, 4 Jan 2007 14:39:00 -0500
>
> > Is there a way to globally set the solder mask clearance on a board?  
> All I
> > want to do is set the clearance as X around all pins/pads.
>
> :MinMaskGap(amount,units)
>
> Example for pcbpool:
>
> :MinMaskGap(0.075,mm)
>
> (or for lesstif, :MinMaskGap 0.075 mm)
>
> Note: it won't decrease a too-big mask, just increase a too-small
> mask.  You can use ChangeClearSize (when the mask is showing) to set
> all selected pins/pads to, say, 1, then grow them with MinMaskGap.
>
>
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

_________________________________________________________________
Dave vs. Carl: The Insignificant Championship Series.  Who will win? 
http://clk.atdmt.com/MSN/go/msnnkwsp0070000001msn/direct/01/?href=http://davevscarl.spaces.live.com/?icid=T001MSN38C07001



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user