Re: gEDA-user: Solder Mask Clearance

["Mike Hansen" <mehansen10@xxxxxxxxxxx>]

Newbie questions here:

-I pulled down what is in CVS by pulling down the "pcb" module, I am 
assuming this is what is meant by HEAD.
-./configure works fine on this source.
-make fails with the following errors:
it can't find puller.png or thermal.png



> From: DJ Delorie <dj@xxxxxxxxxxx>
> Reply-To: gEDA user mailing list <geda-user@xxxxxxxxxxxxxx>
> To: geda-user@xxxxxxxxxxxxxx
> Subject: Re: gEDA-user: Solder Mask Clearance
> Date: Thu, 4 Jan 2007 23:05:39 -0500
>
> > Is there a developer snapshot available or am I out of luck?
>
> Just get cvs head at the moment, it's stable.  Build it but don't
> install it, run pcb-bin out of the build directory.
>
>
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

_________________________________________________________________
Get live scores and news about your team: Add the Live.com Football Page 
www.live.com/?addtemplate=football&icid=T001MSN30A0701



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user