Re: gEDA-user: compiling gaf from git repos

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Wed, 2009-01-14 at 09:29 -0600, John Griessen wrote:
> I compile OK from pcjc2's cairo_place_lines  branch,
> 
> but when I cloned http://git.gpleda.org/, made a new branch from master  It stops at libgeda with errors.
> 
> Is master the right branch to use?

master is good. It now has far more cairo support than the above branch
you mentioned.

To get libgeda building, you may need to:

make reconfig
make install

at toplevel.

Failing that:

make reconfig
make libgeda_config
make libgeda_install
make config
make install

(That probably duplicates a build or two, but since libgeda isn't "make
clean"'d in between, it ought to be fairly fast).


-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user