Re: gEDA-user: compiling gaf from git repos

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Wed, 2009-01-14 at 19:06 +0000, Kai-Martin Knaak wrote:
> On Wed, 14 Jan 2009 15:58:40 +0000, Peter Clifton wrote:
> 
> Just tried this route to get a fresh geda from git:
> 
> $ git clone git://git.gpleda.org/gaf
> $ cd gaf
> $ gedit Makefile    # change destination dir
> $ make reconfig
> $ make install
> 
> However, make install produced a syntax error during config:

Try installing newer libtool.

If that fails, try removing both the [shared] and [win32-dll] options.
(Separately, then both.)

Please report back!

If its too much of a burden, I'll put the old (deprecated) syntax back.

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user