|
After positioning all components on the circuit
board, and optimizing the rats nest, I attempted to perform an autoroute rats
nest and get a segmentation fault. The board is primarily through hole
components except 2 micro max 8pin IC's.
I am running RH-9 on a PIII-450 w/ 512 MB of
ram. My first instinct was to upgrade the version of gEDA that shipped
with RH-9, but when this didn't solve the segmentation fault problem, I decided
to turn to the list.
My primary question is there a file someplace that
PCB can't find? Or is there a limitation on the type of SMT IC's I can
use.
Thank you for your attention.
Chris Warner
|
No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.0.338 / Virus Database: 267.9.7/60 - Release Date: 7/28/2005