Re: gEDA-user: Segmentation fault during Autorouting of rats nest on PCB 20050315

["harry eaton" <bumpelo@xxxxxxxxxxx>]

I'm guessing its just an ordinary bug. Probably you have some strange
circumstance that wasn't anticipated in the auto-router code. Can you send
me your pcb file and I will try to replicate and resolve the error?

harry

----- Original Message -----
From: "Chris Warner" <bearz2@xxxxxxx>
To: <geda-user@xxxxxxxxxxxxx>
Sent: Friday, July 29, 2005 5:10 PM
Subject: gEDA-user: Segmentation fault during Autorouting of rats nest on
PCB 20050315


After positioning all components on the circuit board, and optimizing the
rats nest, I attempted to perform an autoroute rats nest and get a
segmentation fault.  The board is primarily through hole components except 2
micro max 8pin IC's.

I am running RH-9 on a PIII-450 w/ 512 MB of ram.  My first instinct was to
upgrade the version of gEDA that shipped with RH-9, but when this didn't
solve the segmentation fault problem, I decided to turn to the list.

My primary question is there a file someplace that PCB can't find?  Or is
there a limitation on the type of SMT IC's I can use.

Thank you for your attention.
Chris Warner


----------------------------------------------------------------------------
----


No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.338 / Virus Database: 267.9.7/60 - Release Date: 7/28/05