Re: gEDA-user: pcb DRC a bit odd

[Ian Chapman <ichapman@xxxxxxxxxxxx>]

On Thu, 2008-07-03 at 13:31 -0700, Ben Jackson wrote:
> On Thu, Jul 03, 2008 at 02:34:11PM -0400, Ian Chapman wrote:
> > Hi,  My pcb has passed DFM at a two fab shops (4pcb and Sierra) with 5.8
> > mil spacing.  When I set file/preferences/size/DRC cu space to 5 mil and
> > run pcb drc it gives me the x, y to the centre point of a highlighted
> > race and I'm not able to see why.  Any ideas?  Regards Ian.
> 
> The PCB DRC is a bit user-unfriendly.  In the case of lines it always shows
> you the center of the line, not the problem.  Look at the entire line
> segment.
Thanks Ben, I figure that out myself.  John's message about clear flags
looks worth investigating and I will once I find them under the menu.
So far it has me beat.  Regards Ian.
> 



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user