Re: gEDA-user: pcb DRC a bit odd

[Ben Jackson <ben@xxxxxxx>]

On Thu, Jul 03, 2008 at 02:34:11PM -0400, Ian Chapman wrote:
> Hi,  My pcb has passed DFM at a two fab shops (4pcb and Sierra) with 5.8
> mil spacing.  When I set file/preferences/size/DRC cu space to 5 mil and
> run pcb drc it gives me the x, y to the centre point of a highlighted
> race and I'm not able to see why.  Any ideas?  Regards Ian.

The PCB DRC is a bit user-unfriendly.  In the case of lines it always shows
you the center of the line, not the problem.  Look at the entire line
segment.

-- 
Ben Jackson AD7GD
<ben@xxxxxxx>
http://www.ben.com/


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user