Re: gEDA-user: geda-user Digest, Vol 26, Issue 47

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Wed, 2008-07-23 at 14:49 -0400, Vincent Onelli wrote:

> Thank you so mutch, this works
> Here is another question, can I setup board size width and hight
> larger then 
> is need and then draw an outline for the proper size required? This
> will 
> accomodate any shape board
> Thank you again. Vinny

Yes, just rename one of the layers "outline" (or add it as a new layer),
and the right thing will happen.

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user