Re: gEDA-user: RFC refdes positions on pcb

[John Luciani <jluciani@xxxxxxxxx>]

   On Wed, Jul 29, 2009 at 10:21 PM, gene glick
   <[1]carzrgr8@xxxxxxxxxxxxx> wrote:

     Any comments on this sort of refdes position?
     [2]http://geocities.com/motorcity/9424/geda/refdes_sample.png

   I would find it difficult to use. Rather than reading a refdes you
   have
   to perform a lookup.
   Since S6.S401 is repeated for all refdeses can you just put a box
   around
   the sub-circuit and label it S6.S401? You could then replace the three
   character key with a three character refdes.
   The table consumes a lot of board area which can not be used for
   components or vias.
   (* jcl *)

   --
   You can't create open hardware with closed EDA tools.
   [3]http://www.luciani.org

References

   1. mailto:carzrgr8@xxxxxxxxxxxxx
   2. http://geocities.com/motorcity/9424/geda/refdes_sample.png
   3. http://www.luciani.org/


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user