Re: gEDA-user: Trace width/quality

[Greg Cunningham <greg@xxxxxxxxxxxxxxxxxxxx>]

I had the same problem on a lo-end Brother HL10-h & a hi-end Lexmark
W810. it was like a plumbing maze with no elbows.

ggv was OK with postscript & pdf. My final film output was thru a
Harlequin RIP & Dainippon FT-R3050 film processor & it was fine, so I
didn't pursue it...
-- 
Greg Cunningham

On Wed, 2005-06-29 at 07:33, John Coppens wrote:
> Hello people.
> 
> I'm using PCB for small projects, and recently acquired a laser printer,
> half justifying it to print PCB boards.
> 
> When I print the postscript file out of PCB with Ghostview, traces are
> too wide and there seems to be a problem with rounding. Importing the file
> into Gimp at 600dpi, then printing gives nice results but is quite slow.
> 
> I'm using the hpijs driver, gs and the ppd file for my printer.
> 
> Could someone indicate where I could tweak things to improve the result?
> 
> I've attached two small images to illustrate the results - I hope this is
> permitted on the list...
> 
> TIA,
> John