Re: gEDA-user: How to?

[DJ Delorie <dj@xxxxxxxxxxx>]

> Working on a pcb here, and the question arises: "How do I control the
> width of traces used for thermal reliefs?"  Most of my thermal reliefs
> look OK, but I have a limited few that have terribly thin relief traces.

Thermal finger width is proportional to the copper annulus gap.  So,
increasing the copper gap also increases the thermal finger width.

You can also edit the Thermal[] line in your *.pcb file to change the
proportion; it's copper to diameter change, so 0.5 means "same as
gap", 1.0 means "twice as thick as gap", etc.


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user