On Sat, Jun 21, 2008 at 3:20 PM, DJ Delorie <
dj@xxxxxxxxxxx> wrote:
> How do I convert my pcb with routed tracks to leave the rest of the
> copper as a ground plane covering as much of the PCB as possible,
> without leaving unconnected metallized areas?
Assuming you've had the "new lines clear polygons" flag set
throughout, just draw a rectangle over your whole board and connect it
to something.
If you haven't set that flag, search the archives for ways to set it
for your whole board. Also look up MorphPolygon() in case you have
multiple disjoint blank areas on your board.
_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user