Re: gEDA-user: Unplated pin with one-side copper ring

[John Luciani <jluciani@xxxxxxxxx>]

   On Mon, Jun 1, 2009 at 8:35 AM, Tamas Szabo <[1]sza2king@xxxxxxxxxxx>
   wrote:

     Hi,
     Can I make a pin without plating and put the footprint only to the
     component side? If yes, how can I do it?

   It sounds like you want a copper ring with an unplated hole. IIRC
   pins create copper on both sides.
   A square pad with rounded corners is a circle. You could try placing a
   mounting hole in the center of a component side square pad with
   rounded corners. The fab may not produce a clean edge on the hole.
   (* jcl *)

     Thanks,
     /sza2
     _______________________________________________
     geda-user mailing list
     [2]geda-user@xxxxxxxxxxxxxx
     [3]http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

   --
   You can't create open hardware with closed EDA tools.
   [4]http://www.luciani.org

References

   1. mailto:sza2king@xxxxxxxxxxx
   2. mailto:geda-user@xxxxxxxxxxxxxx
   3. http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
   4. http://www.luciani.org/


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user