[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
Re: gEDA-user: minor PS output issues
On Sat, 2009-06-20 at 17:27 +0000, Kai-Martin Knaak wrote:
> Just came across two minor postscript issues:
>
> * The index page talks about "top"/"bottom", but the files are named with
> "front"/"back". Pcb should stick to one layer name pattern. I'd very much
> prefer top/bottom, as all the fabs I worked with seem to use this scheme.
ACK, that would be good.
> * Peter Cliftons "after pours" version of pcb the produces assembly
> prints in $NAME_front.ps and $NAME_back.ps if the multifile is chosen.
> That is, these files contain copper plus silk, rather than copper only.
> This my be related: Without the multifile option there are an additional
> two, empty pages in the document.
Yes - I broke something somewhere in my tree, and haven't had chance to
go hunting for it yet.
--
Peter Clifton
Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA
Tel: +44 (0)7729 980173 - (No signal in the lab!)
_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user