Re: gEDA-user: newbie opamp blues

[sdb@xxxxxxxxxx (Stuart Brorson)]

> OK, maybe now you'll give me a little credit. I apologize for not having 
> the time to fiddle with this until I can figure out how to get it work, 
> but I have a LOT of work to do already.

Credit where credit's due!  Good work on trying!  Keep up the good work!

> Missing Attributes (refdes and pin number)
> Missing Attributes (refdes and pin number)
> Missing Attributes (refdes and pin number)
> Missing Attributes (refdes and pin number)
[. . . snip! . . .]

> Any ideas?  I didn't recopy your opamp-1.sym because one already 
> existed. Is the one that already exists defective?

It looks to me like your symbol is defective.  Try one of these:

1.  Look at the pin attributes on the symbol itself.  Verify that all
    pins have a pinnumber attribute.
2.  Run "gsymcheck" on the symbol you want to use.  It will tell you
    if your symbol has a problem.
3.  Use the opamp symbol I posted last time.  It has all pin attrbutes
    already set up for use in op amp simulations.
4.  Post your schematic and op amp symbol here for us to look at &
    check.

Also, did you set the "refdes" attribute in your opamp?

Stuart