Re: gEDA-user: installation problem

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Fri, 2008-03-21 at 13:47 +0100, Willem Granjé wrote:
> Hello,
> 
> I upgraded geda to 1.4,
> 
> starting gschem revealed that the component-library could not be found
> anymore...
> 
> where is it, how do I configure gschem to find it?

Let me guess.. Debian testing?

Last I checked, not all of gEDA 1.4.0 had migeated to testing. There is
an incompatibility between gEDA symbols 1.4.0 (in testing) and the old
version of libgeda + gschem (not yet in testing).


You could either fetch all the 1.4.0 packages from Unstable (sid), or
move the component library config file from its new (1.4.0) location
back to its old (pre 1.4.0):

mv /usr/share/gEDA/gafrc.d/geda-clib.scm /usr/share/gEDA/scheme/

You may need to revert this once the rest of gEDA is installed.


Alternatively, if I guessed wrong, and you do have gschem and libgeda
1.4.0 fully installed (you should be able to see the version strings
when starting up gschem from a command line), then perhaps you haven't
got geda-symbols 1.4.0 properly installed.

Best wishes,

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user