Re: gEDA-user: multi-slot symbol with different graphics

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Wed, 2008-05-14 at 06:56 -0400, gene wrote:
> Is this possible?  There's a device that has 2 bjt's in it, 1 is npn the 
> other is pnp.  It might be nicer on the schematic to have it in 2 slots 
> so placement is neater.  But how would the 2 slots use different graphic 
> elements?

You need two symbols, no reason you can't give them the same refdes, and
make sure the pin-numbers of each half are correct for that portion of
the device.

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user