Re: gEDA-user: Rubber Bands

[Stefan Salewski <mail@xxxxxxxxxxxx>]

On Wed, 2009-05-06 at 15:06 -0700, Lance Earl wrote:
> Hi, 
> 
> I am sure that this is a stupid question but I have dug through the
> documentation for PCB and cannot find an answer.
> 
> I have turned rubber band mode on. I assume that this is to make nets
> sticky on pads so that they will move when I move a foot print. The
> problem is that some get sticky and some don't. Any ideas why?
> 
> Lance
> 

Please note: Rubberband is only active when element is NOT
selected/highlighted. Move pointer over the element, press LMB and move
element. If you select the element first, and then move it, then
rubberband does not work.

Of course rats lines are always in rubberband mode.




_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user