[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
Re: gEDA-user: ??Error message PCB??
Ok, Added both commands in the gsch2pcb project file and run gsch2pcb
again. That is correct?
Then I got a error message on line 36? and that is =>
FileVersion[20070407]
Some more of the file:
Element[0x0 "1210.fp" "M1/L3" "4.7uH/0.9A/0.2R" 0 0 -10161 -13783 0
100 0x0]
(
Pad[-5511 -2165 -5511 2165 6299 2000 8299 "input" "1" 0x0100]
Pad[5511 -2165 5511 2165 6299 2000 8299 "input" "2" 0x0100]
ElementLine[-10161 6814 -10161 -6814 1000]
ElementLine[-10161 -6814 10161 -6814 1000]
ElementLine[10161 -6814 10161 6814 1000]
ElementLine[10161 6814 -10161 6814 1000]
)
Element[0x0 "0805.fp" "M1/C29" "1uF" 0 0 -7799 -11421 0 100 0x0]
(
Pad[-3740 -393 -3740 393 5118 2000 7118 "input" "1" 0x0100]
Pad[3740 -393 3740 393 5118 2000 7118 "input" "2" 0x0100]
ElementLine[-7799 4452 -7799 -4452 1000]
ElementLine[-7799 -4452 7799 -4452 1000]
ElementLine[7799 -4452 7799 4452 1000]
ElementLine[7799 4452 -7799 4452 1000]
)
FileVersion[20070407]
------------------
Did I correctly disabled the M4 lib? Or is there an other problem.
2009/5/23 Ben Jackson <[1]ben@xxxxxxx>
On Sat, May 23, 2009 at 08:42:48AM +0200, Ernst van Spronsen wrote:
>
> Ok, How do I disable the M4 libraries? At least for this project?
> Thanks.
In your project file add:
use-files
skip-m4
--
Ben Jackson AD7GD
<[2]ben@xxxxxxx>
[3]http://www.ben.com/
_______________________________________________
geda-user mailing list
[4]geda-user@xxxxxxxxxxxxxx
[5]http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
References
1. mailto:ben@xxxxxxx
2. mailto:ben@xxxxxxx
3. http://www.ben.com/
4. mailto:geda-user@xxxxxxxxxxxxxx
5. http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user