Re: gEDA-user: gsch2pcb to pcb error

[Mike Bushroe <mbushroe@xxxxxxxxx>]

     > I still
     > NEVER managed to get any footprint libraries added, even after
     using gafrc
     > in /gaf, gafrc in /motherboard, setting the PCBLIBPATH environment
     variable
     Those don't set the paths!  You have to pass them to the file
     gsc2pcb
     reads, which I name *.prj.

   I forgot to mention I put several lines in the project file. I am still
   new enough to just call it 'project'. The file is:
   component-library /home/mike/gaf/symbols
   element-library /home/mike/gaf/packages
   element-dir /home/mike/gaf/packages
   schematics ATMega164P_motherboard.sch ROV_2010_analog.sch
   ROV_2010_power.sch ROV_2010_Hydraulics.sch ROV_2010_I2C.sch
   ROV_2010_subprocesser.sch ROV_2010_camera.sch
   output -name ROV-2010_motherboard

     > ).fp(RCY200.fp,C26,150pf)
     This means you have a fooprint with a subtaction ("-") in the
     filename.

   No subtaction in the file name, file, or footprint attribute. But I
   _did_ discover when reading the schematic files with gedit that some
   entries had TWO footprint attributes. When I ran gattrib this was not
   evident. They seem to be faster to find with gedit highlighting each
   'footprint=' and just looking for two that are too close together. It
   would be nice if drc2 or gattrib would warn about this kind of problem.
   Mike


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user