On Sat, 2011-05-14 at 16:36 +0200, Felix Ruoff wrote:
> In the default-konfiguration, the '='-Key is for 'Simple optimization'
> from the 'Connects' menu. I can imagine, that this needs some time, but
> I have not tested it now.
> You can disable/modify this by editing the file 'gpcb-menu.res'. There
> is a line
> {"Simple optimization" djopt(simple) a={"=" "<Key>="}}
> . The Values in the braces after 'a=' are the key-bindings for the
> action 'djopt(auto)'. Just the second value ("<Key>=") is relevant, if
> you are using the gtk-gui. If you use the lesstiff-gui, there is a
> special file 'pcb-menu.res'. You can set anoter (unused) key instead of
> the two '=' or remove the whole part 'a={"=" "<Key>="}', what will
> remove this key-binding for this menu-item.
Yes, I can recommend removing this key binding.
I do in my local builds for the same reason, plus the fact that
sometimes the optimiser makes mistakes and causes shorts on my boards!
--
Peter Clifton
Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA
Tel: +44 (0)7729 980173 - (No signal in the lab!)
Tel: +44 (0)1223 748328 - (Shared lab phone, ask for me)
Attachment:
signature.asc
Description: This is a digitally signed message part
_______________________________________________ geda-user mailing list geda-user@xxxxxxxxxxxxxx http://www.seul.org/cgi-bin/mailman/listinfo/geda-user