Re: gEDA-user: pcb text

[joeft <joeft@xxxxxxxxxxxxx>]

DJ

I think you've explained the behavior I've viewed as a bug.  The pin 
numbering code should allow narrow lines for readability while you are 
editing - this is good.  However, the silkscreen text must be drawn with 
accurate width in the editor so that it can be placed to prevent their 
landing on pads etc.  Allowing it to be artificially thin can get you in 
trouble.

Joe T



DJ Delorie wrote:

> > Could anyone tell me what is going on?
> >    
>
> The gerbers and PS output honor the "minimum silk thickness" DRC
> setting.  The GUI doesn't.  The reason it's not fixed is because the
> same code does the pinout numbers, and if you make them thick enough
> they're just blobs.
>
>
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>
>  



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user