Hi Giorgenes,
On Saturday 11 November 2006 22:24, Giorgenes Gelatti wrote:
> Following the "my schematic doesn't work" series, I have another
> problem. I was doing my schematic in ubuntu dapper and now I changed
> to edgy. What happens is that when I open my schematic, I can't
> connect any new nets. They seem to get aligned off grid.
> I mean, I can create the nets, but they don't get connected to any
> component. Plus, I`m getting some warning on stdout:
Only the connector on the left side and the neighbour nets are offgrid.
Either:
* remove the offgrid things and add them again.
* Toggle snap off, and move the part back to the 100mils grid
Maybe you have added/moved the connector while the snap grid was off.
> WARNING: Symbol version mismatch on refdes C101 (capacitor-2.sym):
> Symbol in library is newer than instantiated symbol
> Minor version change (file 0.100, instantiated 0.000)
It's a new symbol in die Library. You can mark the schematic and do an
Edit->Update Component.
Then the new version number of the library is imported to the schematic.
> My schematic is attached.
Attached a clean version without connector.
Regards
Werner
_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user