Re: gEDA-user: Strange issue with images and printing

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Wed, 2007-11-28 at 19:12 -0700, Steven Ball wrote:
> 	
> Howdy guys,
> 
> I'd noted this before, but it had been a while and it still seems to  
> be an issue.
> 
> If I place an image, say, a logo, on my schematic, if I do not zoom in  
> on it before printing, gschem will print it very blocky, like it  
> scales it to what it is currently set to on the screen inside of  
> scaling it properly for print.
> 
> Confused?
> 
> OK, if I zoom extents, and print, the resultant print (or postscript)  
> ends up with a chunky, distorted image.
> 
> If I zoom in such that the image completely fills my screen, and print  
> again, the image comes out looking perfect.
> 
> Wonder what does that?

Can you file a bug report please..

http://sourceforge.net/tracker/?group_id=161080&atid=818426

I suspect its scaling the on-screen version it's scaled for the screen,
rather than trying to scale the original image.

Thanks,

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user