[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
Re: gEDA-user: More questions about pcb
On 11/24/09, Atommann <atommann@xxxxxxxxx> wrote:
> Hi,
>> Second question, is there a ruler tool in pcb?
>>
>
> I observe the coordinate and make subtraction.
Ctrl-M in default bindings marks a point, then dx, dy, phi and r are
shown near the coordinates - top right in GTK, low left in Lesstif.
Regards,
Ineiev
_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user