Re: gEDA-user: About polygon clearances

[Stefan Salewski <mail@xxxxxxxxxxxx>]

Am Dienstag, den 21.10.2008, 15:21 +0000 schrieb Eduardo Santana:
> Hello guys,
> 

I think you have component and GND layer in the same layer group, so
same physical copper layer is used. But your traces cut inner area from
outer area. There would be no electrical connection. If you connect
outer area to your ground signal GND, inner is not connected, it is only
an copper area connected to nothing, so pcb program deletes it.

You may make a connection, or use different groups for component and GND
to make a two sided board.

Just my guess.
 



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user