Re: gEDA-user: rotate smd parts 0603

[Stefan Salewski <mail@xxxxxxxxxxxx>]

On Mon, 2009-10-12 at 16:10 +0200, Stefan Salewski wrote:
> On Mon, 2009-10-12 at 16:05 +0200, Klaus Rudolph wrote:
> > Hi all,
> > 
> > I try to rotate some smd parts (0603) on the layout,m but only the silk 
> > layer rotates. If I switch of the silk layer, I could not rotate 
> > anything. Rotating SO14 is working. Sorry, I am to silly to rotate a 
> > simple smd device :-)
> > 
> > Any trick?
> > 
> 
> Which program?
> 
> Which version of the program?
> 
> Which angle?
> 
> Which command/action did you try.
> 
> Footprint shipped with the program, or made yourself?
> 
> 

I think for PCB there was a problem when pads are exact squares, but I
can not remember if this is for 90 degree rotation or only for arbitrary
rotations. For this case make the pad not exact sqaure, i.e. increase
one dimension minimal.




_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user