gEDA-user: PCB GL How to return to normal view

[michalwd1979 <michalwd1979@xxxxx>]

Hello all,
I'm just started using GL version of PCB and I can not find out how to return to normal view. I open the board then use 3d "trackball" to change view and then I want to return to "normal" 2d view as at the start. Is there any keystroke or command for this? Trying to get back using trackball is hard and very time consuming.

The other problem is that I can not see any 3d view on my screen. I expected to see something like on screen-shots presented by Peter Clifton (holes in pads/vias, tracks at different levels), but here everything is flat. The view angle changes and rotates right. Am I missing some switch,flag or set up something wrong? I'm trying to find out what is wrong since 2 hours and no luck :-(.

Anyway: I think that this is a very nice idea. Thanks PCB developers, good work!

Regards,
Michael W.





_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user