Re: gEDA-user: PCB GL How to return to normal view

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Mon, 2009-10-19 at 20:28 +0200, michalwd1979 wrote:
> Hello all,
> I'm just started using GL version of PCB and I can not find out how to
> return to normal view. I open the board then use 3d "trackball" to
> change view and then I want to return to "normal" 2d view as at the
> start. Is there any keystroke or command for this? Trying to get back
> using trackball is hard and very time consuming.

Nothing yet.. I'll add it!

> The other problem is that I can not see any 3d view on my screen. I
> expected to see something like on screen-shots presented by Peter
> Clifton (holes in pads/vias, tracks at different levels), but here
> everything is flat. The view angle changes and rotates right. Am I
> missing some switch,flag or set up something wrong? I'm trying to find
> out what is wrong since 2 hours and no luck :-(.

I suspect you have checked out the "before_pours" branch, you want
"local_customisation_before_pours".

Best wishes,

Peter C.




_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user