Re: gEDA-user: PCB grid question

[DJ Delorie <dj@xxxxxxxxxxx>]

There is no "official" way because it's a physics problem, not a
software problem.  Do whatever seems to work for you.

You can use one element's pins to snap another element to match it's
off-grid placement, for example, or draw a trace first and snap an
element to it's endpoint.  But most of the time you just put a jog in
the trace halfway between the elements, so they each get a trace going
straight in.  This assumes you're using "\_" mode, where the angled
part of the two-segment trace is drawn first, to land on the off-grid
element.


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user