Re: gEDA-user: PCB grid question

[michalwd1979 <michalwd1979@xxxxx>]

Thank You all for replies!

Yes I know about "snap to pins" option. I'm using opengl version compiled from git, and I did not noticed 2 snapping points for pads. 

Regards,
Michael W.

Dnia 21 października 2009 22:46 Stefan Salewski <mail@xxxxxxxxxxxx> napisał(a):

> On Wed, 2009-10-21 at 22:12 +0200, michalwd1979 wrote:
> > Hello,
> > 
> > During design of my first more complicated board I run into problems
> > with grids - element's pins often do not fall onto grid point. 
> 
> Sure -- if I have an element with 0.65 mm pitch and one with 0.5 mm
> pitch it will not fit nice.
> 
> I assume you know that "Settings/Crosshair snaps to Pins/Pads" can help
> to ensure that traces go to the center of pads. And that you know that
> you can grab elements at center or at individual pads for positioning.
> (For version 20081128 pads have two snapping points -- not always what I
> want...)
> 
> 
> 
> 
> 
> 
> 
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
> 


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user