Stuart Brorson wrote: > Thanks to DJ and John for quick responses. > > As you both guessed, I once again proved that I am a bonehead. After > posting, I discovered two additional rats hiding in the corner of the > board. I connected those two nets, and then when I hit "o" to refresh > the rats I got the "congratulations, you are done" message. >
I'm suprised you don't get a message when there are incomplete nets from looking at the code. However, from trying it I see you don't get a message. Perhaps this should be changed to something like "<n> rat lines remaining".
What do you think?
A small message in the status line that is continuously updated would be nice.
Or will people get tired of that message since I assume many people wear out the 'o' key like I do in pcb.
It would be nice if the 'optimize' command was automagically run just prior to running a trace (which would save my 'o' key). I usually press 'o' and then start to run a trace.
Having it run during any idle time would also work (for me).
(* jcl *)
-- http://www.luciani.org
_______________________________________________ geda-user mailing list geda-user@xxxxxxxxxxxxxx http://www.seul.org/cgi-bin/mailman/listinfo/geda-user