Re: gEDA-user: pcb-20070912

[Peter Baxendale <peter.baxendale@xxxxxxxxxxxx>]

This isn't the problem I reported a while back is it? Fedora 7 comes
with automake 1.10 and doesn't include aclocal-1.9. Configure apparently
runs ok and you can miss the error message when you run make. I ran
autogen.sh first, and then everything is happy.


On Fri, 2007-09-14 at 17:30 +0100, Peter Clifton wrote:
> On Fri, 2007-09-14 at 09:52 -0500, Harold D. Skank wrote:
> > Dan,
> > 
> > I've awaited this release for some time now, as I've been having
> > difficulty with some polygon issues on a large design.  However,
> > following download, I was some surprised that I could not get the file
> > to compile.
> > 
> > I should mention that I'm running Fedora-7 on an AMD-64, and I was
> > attempting to compile in the 32-bit mode to avoid some operational
> > issues that I have faced.  I could run:
> > 
> >   CFLAGS='m32" ./configure --with-hid=gtk
> > 
> > however a subsequent "make" command responded as though "configure" had
> > not completed.  In the end I had to go back to pcb-20070208.
> 

-- 
Peter Baxendale <peter.baxendale@xxxxxxxxxxxx>



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user