Re: gEDA-user: QFN soldering

[timecop <timecop@xxxxxxxxx>]

get a stencil, get solder paste, apply paste over stencil, heatgun, done.
super simple. dont even bother doing it "manually" pin to pin, it
probably wont work.

On Mon, Sep 13, 2010 at 10:46 AM, gene glick <carzrgr8@xxxxxxxxxxxxx> wrote:
> does anyone have experience with this package?  I want to know if they
> are hard to work with.  The exposed pad underneath is a problem for hand
> soldering - but maybe could be left unsoldered for prototypes.  Maybe
> just place some solder paste under there ?  If the pcb pads are long
> enough, is it feasible to solder to the edge of the chip instead of
> getting it underneath the device?
>
> thanks
>
> gene
>
>
>
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user