Re: gEDA-user: pcb, howto get plain rats lines instead of circles

[Stefan Salewski <mail@xxxxxxxxxxxx>]

Am Dienstag, den 07.10.2008, 18:34 +0200 schrieb Stefan Salewski:
>  I will myself make a test with a
> layout created from scratch. 
> 

Done -- same bug.

I used a other, simple schematic used gsch2pcb to generate initial
board, opened board with pcb, imported netlist, dispersed elements, draw
a rectangle, and connected net AGND to this plane. If I position a
capacitor near above or below the plane I get these circles -- on left
and right side all is OK.

http://www.ssalewski.de/tmp/b2.pcb

Best regards

Stefan




_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user