[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
gEDA-user: How to make PCB 1 mm connector?
- To: geda-user@seul.org
- Subject: gEDA-user: How to make PCB 1 mm connector?
- From: Bob Paddock <bpaddock@csonline.net>
- Date: Sun, 11 Apr 2004 09:36:58 -0400
- Delivered-to: archiver@seul.org
- Delivered-to: geda-user-outgoing@seul.org
- Delivered-to: geda-user@seul.org
- Delivery-date: Sun, 11 Apr 2004 09:39:14 -0400
- Organization: The Designer-III Company http://www.designer-iii.com/
- Reply-to: geda-user@seul.org
- Sender: owner-geda-user@seul.org
- User-agent: KMail/1.6.1
I've been trying to make a ten pin version of this 1 mm pitch connector for
PCB:
http://www.jst-mfg.com/ProductGuideE/EFPZ.html
http://www.jst-mfg.com/pdfE/eFPZ.pdf
I've tried drawing it then converting it to a element, but the resulting
element says it has > 200+ pins. A pin for each line segment that
made up the ten filed 1mm pads.
Since you can't use rectangles for pad elements how do you make
a filed rectangular pad out of line segments, that is only one pin,
with 1mm spacing?