Re: gEDA-user: Naming nets across sheets

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Wed, 2008-04-30 at 14:37 +0100, Peter TB Brett wrote:
> On Wednesday 30 April 2008 14:20:37 James Moody wrote:
> > My circuit design spans 2 sheets. To carry the signal from one to the
> > other I used the output and input flags, and added the attribute
> > "netname=CH A_1" to the output on one page and the corresponding input
> > on the other page.  I did the same with "CH A_2", "CH B_1" and "CH B_2".
> > In the resulting netlist these nodes are unnamed, and the connection
> > between sheets was not made.  I tried again after removing the space in
> > the value; no difference.
> >
> 
> Netname attributes should be attached to the net segments themselves. At the 
> moment, the input/output flags are only used for heirachy.

A "net=net_name:1" attached to the input / output connectors works, and
is what I often use.

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user