[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: arcs and circles in PCB via gui

Duncan Drennan <duncan.drennan@xxxxxxxxx> writes:

> Hmmm....figure out how to code pcb....or use vim.....hmmm, I'll have
> to think about it ;)

Whenever I needed arcs on my boards that were not 90 deg (mostly board
outlines), the geometry was so difficult that I used gnumeric to code
the arcs, for cut'n paste into the PCB file.

-- 
Stephan Böttcher                     FAX: +49-431-880-3968
Extraterrestrische Physik            Tel: +49-431-880-2508
I.f.Exp.u.Angew.Physik               mailto:boettcher@xxxxxxxxxxxxxxxxxx
Leibnizstr. 11, 24118 Kiel, Germany


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user