Re: gEDA-user: Any chance to edit Gerbers in gEDA or other Linux software?

[Stefan Salewski <mail@xxxxxxxxxxxx>]

On Fri, 2009-05-01 at 01:15 +0200, Stefan Salewski wrote:
> On Thu, 2009-04-30 at 11:51 -0700, Joerg wrote:
> > Hello,
> > 
> > After some web searching I read that gEDA gerbV will eventually contain 
> > basic editing functions. That post was from earlier this year so I 
> > assume we are quite a while away from that.
> > 
> > Is there another program that can already do that to some extent? 
> > Basically where you can re-route a couple of traces to show someone 
> > "Here, this would be a better way to route that".
> > 
> > So far I am doing that with <gasp> MS-Paint :-)
> > 
> 
> I think there was a similar question in a german uC forum 

OK, this thread, I think you can read german:

http://www.mikrocontroller.net/topic/125535#new






_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user